Energy Control Trainer Vocational Education Equipment Teaching Equipment

ASR6128E Energy Control Trainer Vocational Education Equipment Teaching Equipment
I. Introduction
This experimental device simulates the power supply network. “Energy control the trainer” model in a typical industrial building energy distribution and management are widely used in the study, through the experiment, to master the principle and control mode, the corresponding knowledge and skills, suits, higher vocational colleges, secondary vocational schools and vocational school related professional teaching and skills training examination
II. Training panel instruction
1. Phase change switch
2. AC ammeter –AC 5A.
3. AC voltmeter -AC 450V.
4. Molded case circuit breaker –AC 40A.
5. Transformer — 10:51t.
6. Single-phase electronic meter.
7. Leakage circuit breaker –ADZ47sLE/20A/2P.
8. Wall switch
9. Lamp holder
10. Three-phase four-wire electronic active power meter.
11. Ground wire cable
12. Zero cable
III. Operate instructions
1. Carefully check whether there is any safety hazard in the power supply line before power supply. (for example, the copper wire of the insulating layer breaks out and is not allowed to be used)
2. Connect the three-phase power supply of the laboratory to the molded case circuit breaker, and connect the zero and ground lines to the zero line and ground line.
3. After check and correct, switch the circuit breaker switch to “ON”, switch the 2P circuit breaker, turn ON the wall switch, and turn ON the light bulb, so that the whole power supply system is fully supplied.