AC Circuit Output Module Electronics Trainer Vocational Training Equipment

ASR6102E AC Circuit Output Module Electronics Trainer Vocational Training Equipment
1 Introduction
This experimental device can provide ac power supply, the output of circuit breaker and fuse protection, can provide 42V/8A and 380V/1A AC. Configuration of digital voltmeter, voltage commutation switch, digital ammeter, can complete a variety of measurements.
2.Technical data
Power supply; output: protected with thermal relays and fuses: 42V AC., 8A, 3 phase (380V AC) 1 A for mains voltage version). Instruments: 3-digit electronic voltmeter, switchable on the three phases; 3-digits electronic ammeter,
3. Detailed technical data
1. AAC380V total power supply —- -4p leakage circuit breaker.
1. AAC42V/8A power supply — -2p circuit breaker.
2. Three phase indicator light.
3. Three-phase insurance
4. Three-phase five-wire output terminal.
5. AAC42V/8A output terminals and insurance.
6. AAC42V/8A output terminals and insurance.
7. AAC42V/8A output indicator light.
8. Ac voltmeter –AAC500V.
9. Commutation switch
10. Ac ammeter -AAC8A.
11. AAC500V voltmeter measuring control switch (note: set to the left side, with the use of reversing switch, the internal three-phase power supply can be tested; To the right, use the test line to test the voltage of the external output terminal.
4. Operate instructions
1. Carefully check whether there is any safety hazard in the power supply line before power supply. (for example, the copper wire of the insulating layer breaks out and is forbidden to be used; Whether the terminal screws are loose)
2. Connect the terminals on the power supply wire of the three-phase five-wire system in the laboratory (black, green, red, AL1, AL2, AL3; Blue line zero; Double – color ground wire), power supply to the experimental box.
3. After the check is correct, power the 4P leakage circuit breaker, and the whole device circuit is connected. If you use AAC42V/8A power supply, please power the 2P circuit breaker.
4. When measuring voltage, dial the voltage meter to the left and cooperate with the reversing switch to test the internal three-phase power supply and determine whether the phase is missing; To the right, use the test line to test the voltage on the external output terminals and the ac voltage on other devices.